In cold storages,after a certain time of operation,there is build up of ice on the cooler fans and a defrosting cycle must take place.
Electrical resistances are inserted between the fans to melt the ice,and the water is collected and passed through drain pipes for disposal.Some waters if the drain pipes are inside the cold storage,so consequently the water may freeze again.To avoid this problem,a drainpipe antifreezing cable is inserted into the pipe.It is switched on only during the defrosting cycle.
End of cable | waterproof silicone moulding |
Cold tail | 0.2~2m |
Output power | 40 or 50w/m |
Tolerance | 5% on resistance |
Voltage | 230V |
Surface temperature | -70~200℃ |
Configuration
1)totally waterproof
2)double insulation
3)moulded terminations
4)extremely flexible
Features of the drainpipe antifreezing Cable
Low installation and maintenance cost.
Versatile to accommodate any layout configuration.
Durable construction.
Smart alternative to snow plowing and chemical snow melting.
Note
The heating cable with 50W/m are most commonly used.
For plastic popes however we recommend the use of heaters with 40W/m.
Warning
These cables can not be cut to reduce cold tail length.
BNDPH-1 | BNDPH-2 |
Note: NO cold zone on the heating belt, The leading wire out of heating belt | Note: The cold zone with heating zone together |
 | |
|  |
Length of heating belt :m | 40W/m | 50W/m |
1.0 | 40W | 50W |
1.3 | 52W | 65W |
1.5 | 60W | 75W |
2.0 | 80W | 100W |
3.0 | 120W | 150W |
4.0 | 160W | 200W |
5.0 | 200W | 250W |
6.0 | 240W | 300W |
* If you have any special requirements, we could also customize for you.
* We could also add a thermostat into this product.
Trade show
Pls advise below details when inquire
(1).Type of Heater
(2).Wattage and Voltage
(3).Dimension of the tube and APPROX length of the heating tube
(4).Drawing required for special configuration
(5).Working environment
As a trustworthy manufacture,we can assure you for:
Consistent&Uniform quality of products throughout the Merchandise.
Shipments well within the time agreed between us.
Most competitive prices and assuring our prooducts quality.
Our belief:
Beno company is a professional Chinese heating element manufacture.
Our focus is on quality control,making excellent before and after-sales service and enlarging product
service and enlarging product series to meet clients'requirements.
Welcome to contact with us,we are always free to answer you question.
We sincere hope to set up good businss relationships with you to create a bright future!
We can send the sample to you for free. you can test our quality!
