Use of heat pipe Note:
1, the components allow the following conditions: A. Air relative humidity of not more than 95%,
no explosive and corrosive gases. B. The operating voltage should not be greater than 1.1 times
the rated value, the shell should be effectively grounded. C. Insulation resistance ≥1MΩ
Dielectric strength: 2KV / 1min.
2, the heat pipe should be fixed positioning, effective heating area must be all immersed in
liquid or solid metal, is strictly prohibited air burning. Found that the surface of the pipe
body scale or carbon, it should be promptly cleaned and re-use, so as not to affect the heat
and shorten the service life.
3, heating fusible metal or solid salt, alkali, asphalt, paraffin, etc., should first reduce
the use of voltage until the media melt, to rise to the rated voltage.
4, heating the elements should be evenly arranged cross, so that the components have a good heat
dissipation conditions, so that the flow of air can be fully heated.
5, heating nitrate should be considered when the safety measures to prevent the explosion.
6, the wiring part should be placed outside the insulation layer, to avoid contact with corrosive,
explosive media, moisture; lead wiring should be able to withstand long-term wiring part of the
temperature and heating load, wire screws should be tightened when tight.
7, the components should be stored in a dry place, if the long-term insulation resistance below
1MΩ, can be about 200 ℃ oven drying, or reduce the voltage power heating until the restoration
of insulation resistance.
8, the heat pipe outlet side of the magnesium oxide powder, in the use of places to avoid
contaminants and water infiltration, to prevent the occurrence of leakage accidents.
Contact Us:
Eric Xie
Tel: +86 15988295936
SKYPE: ericxie123@outlook.com
Whatsapp: +8615988295936
Wechat: +8615988295936
Email: sale@benoelectric.com
Website:www.benoindustry.com
